Transconductance and Coulomb blockade properties of in-plane grown carbon nanotube field effect transistors

Single electron transistors (SETs) made from single wall carbon nanotubes (SWCNTs) are promising for quantum electronic devices operating with ultra-low power consumption and allow fundamental studies of electron transport. We report on SETs made by registered in-plane growth utilizing tailored nanoscale catalyst patterns and chemical vapor deposition. Metallic SWCNTs have been removed by an electrical burn-in technique and the common gate hysteresis was removed using PMMA and baking, leading to field effect transistors with large on/off ratios up to 10^5. Further segmentation into 200 nm short semiconducting SWCNT devices created quantum dots which display conductance oscillations in the Coulomb blockade regime. The demonstrated utilization of registered in-plane growth opens possibilities to create novel SET device geometries which are more complex, i.e. laterally ordered and scalable, as required for advanced quantum electronic devices.Comment: 15 pages, 4 figure

Bright single-photon sources in bottom-up tailored nanowires

The ability to achieve near-unity light extraction efficiency is necessary for a truly deterministic single photon source. The most promising method to reach such high efficiencies is based on embedding single photon emitters in tapered photonic waveguides defined by top-down etching techniques. However, light extraction efficiencies in current top-down approaches are limited by fabrication imperfections and etching induced defects. The efficiency is further tempered by randomly positioned off-axis quantum emitters. Here, we present perfectly positioned single quantum dots on the axis of a tailored nanowire waveguide using bottom-up growth. In comparison to quantum dots in nanowires without waveguide, we demonstrate a 24-fold enhancement in the single photon flux, corresponding to a light extraction efficiency of 42 %. Such high efficiencies in one-dimensional nanowires are promising to transfer quantum information over large distances between remote stationary qubits using flying qubits within the same nanowire p-n junction.Comment: 19 pages, 6 figure

Self-tuned quantum dot gain in photonic crystal lasers

We demonstrate that very few (1 to 3) quantum dots as a gain medium are sufficient to realize a photonic crystal laser based on a high-quality nanocavity. Photon correlation measurements show a transition from a thermal to a coherent light state proving that lasing action occurs at ultra-low thresholds. Observation of lasing is unexpected since the cavity mode is in general not resonant with the discrete quantum dot states and emission at those frequencies is suppressed. In this situation, the quasi-continuous quantum dot states become crucial since they provide an energy-transfer channel into the lasing mode, effectively leading to a self-tuned resonance for the gain medium.Comment: 4 pages, 4 figures, submitted to Phys. Re

Transient chirp in high speed photonic crystal quantum dots lasers with controlled spontaneous emission

We report on a series of experiments on the dynamics of spontaneous emission controlled nanolasers. The laser cavity is a photonic crystal slab cavity, embedding self-assembled quantum dots as gain material. The implementation of cavity electrodynamics effects increases significantly the large signal modulation bandwidth, with measured modulation speeds of the order of 10 GHz while keeping an extinction ratio of 19 dB. A linear transient wavelength shift is reported, corresponding to a chirp of less than 100 pm for a 35-ps laser pulse. We observe that the chirp characteristics are independent of the repetition rate of the laser up to 10 GHz

Nanobeam photonic crystal cavity quantum dot laser

The lasing behavior of one dimensional GaAs nanobeam cavities with embedded InAs quantum dots is studied at room temperature. Lasing is observed throughout the quantum dot PL spectrum, and the wavelength dependence of the threshold is calculated. We study the cavity lasers under both 780 nm and 980 nm pump, finding thresholds as low as 0.3 uW and 19 uW for the two pump wavelengths, respectively. Finally, the nanobeam cavity laser wavelengths are tuned by up to 7 nm by employing a fiber taper in near proximity to the cavities. The fiber taper is used both to efficiently pump the cavity and collect the cavity emission.Comment: 8 pages; 6 figure

Quantum Inductance and High Frequency Oscillators in Graphene Nanoribbons

Here we investigate high frequency AC transport through narrow graphene nanoribbons with topgate potentials that form a localized quantum dot. We show that as a consequence of the finite dwell time of an electron inside the quantum dot (QD), the QD behaves like a classical inductor at sufficiently high frequencies \omega\gtrsim50 GHz. When the geometric capacitance of the topgate and the quantum capacitance of the nanoribbon are accounted for, the admittance of the device behaves like a classical serial RLC circuit with resonant frequencies \omega\sim100-900 GHz and Q-factors greater than 10^{6}. These results indicate that graphene nanoribbons can serve as all-electronic ultra-high frequency oscillators and filters thereby extending the reach of high frequency electronics into new domains

Lasing oscillation in a three-dimensional photonic crystal nanocavity with a complete bandgap

We demonstrate lasing oscillation in a three-dimensional photonic crystal nanocavity. The laser is realized by coupling a cavity mode, which is localized in a complete photonic bandgap and exhibits the highest quality factor of ~38,500, with high-quality semiconductor quantum dots. We show a systematic change in the laser characteristics, including the threshold and the spontaneous emission coupling factor by controlling the crystal size, which consequently changes the strength of photon confinement in the third dimension. This opens up many interesting possibilities for realizing future ultimate light sources and three-dimensional integrated photonic circuits and for more fundamental studies of physics in the field of cavity quantum electrodynamics.Comment: 14 pages, 4 figure

Non-resonant dot-cavity coupling and its applications in resonant quantum dot spectroscopy

We present experimental investigations on the non-resonant dot-cavity coupling of a single quantum dot inside a micro-pillar where the dot has been resonantly excited in the s-shell, thereby avoiding the generation of additional charges in the QD and its surrounding. As a direct proof of the pure single dot-cavity system, strong photon anti-bunching is consistently observed in the autocorrelation functions of the QD and the mode emission, as well as in the cross-correlation function between the dot and mode signals. Strong Stokes and anti-Stokes-like emission is observed for energetic QD-mode detunings of up to ~100 times the QD linewidth. Furthermore, we demonstrate that non-resonant dot-cavity coupling can be utilized to directly monitor and study relevant QD s-shell properties like fine-structure splittings, emission saturation and power broadening, as well as photon statistics with negligible background contributions. Our results open a new perspective on the understanding and implementation of dot-cavity systems for single-photon sources, single and multiple quantum dot lasers, semiconductor cavity quantum electrodynamics, and their implementation, e.g. in quantum information technology.Comment: 17 pages, 4 figure